If there is one thing that drives me nuts, it’s buying a tube of 4200 or Sikaflex or some other expensive tube of sealant but only end up using a small portion of it. Then trying to come up with a way to seal the tip so the rest does not go to waste.
It never works. A few weeks later, I’ll pull out that tube of whatever for another project, only to find the thing will have solidified and I’ll have to make another trip to the hardware store and buy another tube…..until now.
Just look at that beautiful little bastard.
It cost $8 bucks on Amazon for a pack of two. Click here Prazi Usa PR-1600 Seal-A-Tube, 2-Pack
we use these little nozzle condoms:
http://www.leevalley.com/en/wood/page.aspx?p=45858&cat=1,110,42967
Dang, those would work too.
CB…
I’ve had good luck with a papertowel wrapped around, held in place with masking tape. Once it is on squeeze out a bit of caulking into the papertowel. Easily goes a couple weeks. Months not so much.